Configure the ZVOX system
For Soundbases (570, 670, 770) on the front panel of the ZVOX Audio speaker:
a) While the speaker is ON Press and hold down the Mute & Volume Up buttons until you see “PS” on the display.
b) Release the buttons and immediately
c) Press and release the Volume Up button until you see “PS-5” (“PS-3” for Panasonic TV)
d) Wait until the “PS-5” display disappears.
For systems with the Other Settings Button on remote (AV200,AV155, AV157, AV203):
While the speaker is ON press and hold Other Settings for 5 seconds until PS-0 starts flashing then release and adjust with the remotes volume button, move it to PS-5.
For SB Soundbars (SB380, SB400, SB500, SB700):
a) While the speaker is ON Press and hold down the Mute & Volume Up buttons on the side of the speaker until you see “PS” on the display.
b) Release the buttons and immediately
c) Press and release the Volume Up button until you see “PS-5” (“PS-3” for Panasonic TV)
d) Wait until the “PS-5” display disappears.
Configure your Dish Network remote program code to the AUX button
1. On the Dish Network remote control, press and hold the AUX button until all the other mode buttons light up, and then release the AUX button. The AUX button flashes.
2. Enter 0-5-1-2 then press the pound key (#). The AUX key will blink three times. Lock the volume buttons to the ZVOX
1. Press and hold the AUX mode button until all mode buttons are lit, then release it. The AUX mode button will blink.
2 Press the POUND (#) button, press the plus (+) side of the VOLUME button, press the 0 number button, press the POUND (#) button. The AUX mode button flashes three times.
3. Press the SAT mode button then Press the plus (+) and minus (-) sides of the VOLUME button down simultaneously and release them. You have just completed the programming. Now, when you press VOLUME +, VOLUME -, or MUTE, the volume of the ZVOX system is controlled regardless of whether Use the following table to find the remote control code needed for your TV. This table provides the most common remote control codes used by TV manufacturers. The specific buttons each code will enable on your DISH remote may vary by code and by *If your TV does not respond to the DISH remote, try another three-digit remote control code. for instructions on programming your remote using Power Scan or for setting up your remote to function in Limited and SAT Auto Tune modes.Remote Control
How do I program my Dish Network 20.1 remote to my TV?
How do I pair my DISH remote to my TV?