These instructions describe how to configure your Dish Network remote to control the volume from your ZVOX Audio system and not from your TV. The following instructions apply to any TV brand except Panasonic. If you have a Panasonic TV, use the alternate instructions below. FOR ANY TV BRAND EXCEPT PANASONIC: Show Configure the ZVOX system For Soundbases (570, 670, 770) on the front panel of the ZVOX Audio speaker: a) While the speaker is ON Press and hold down the Mute & Volume Up buttons until you see “PS” on the display. For systems with the Other Settings Button on remote (AV200,AV155, AV157, AV203): While the speaker is ON press and hold Other Settings for 5 seconds until PS-0 starts flashing then release and adjust with the remotes volume button, move it to PS-5. For SB Soundbars (SB380, SB400, SB500, SB700): a) While the speaker is ON Press and hold down the Mute & Volume Up buttons on the side of the speaker until you see “PS” on the display. Configure your Dish Network remote program code to the AUX button 1. On the Dish Network remote control, press and hold the AUX button until all the other mode buttons light up, and then release the AUX button. The AUX button flashes. 2. Enter 0-5-1-2 then press the pound key (#). The AUX key will blink three times. Lock the volume buttons to the ZVOX 1. Press and hold the AUX mode button until all mode buttons are lit, then release it. The AUX mode button will blink. 2 Press the POUND (#) button, press the plus (+) side of the VOLUME button, press the 0 number button, press the POUND (#) button. The AUX mode button flashes three times. 3. Press the SAT mode button then Press the plus (+) and minus (-) sides of the VOLUME button down simultaneously and release them. You have just completed the programming. Now, when you press VOLUME +, VOLUME -, or MUTE, the volume of the ZVOX system is controlled regardless of whether Use the following table to find the remote control code needed for your TV. This table provides the most common remote control codes used by TV manufacturers. The specific buttons each code will enable on your DISH remote may vary by code and by *If your TV does not respond to the DISH remote, try another three-digit remote control code. for instructions on programming your remote using Power Scan or for setting up your remote to function in Limited and SAT Auto Tune modes. How do I program my Dish Network 20.1 remote to my TV?Program Remote to TV or Other Device. Press the HOME button twice, or the MENU button once, depending on your remote.. Select Settings.. Select Remote Control.. Arrow to and select the device code you want to learn.. Select the appropriate Pairing Wizard for the device.. Follow the on-screen prompts.. How do I pair my DISH remote to my TV?How to program newer DISH remote controls. Press the Home button on your DISH remote twice. ... . Select Settings from the on-screen menu.. Select Remote Control from the on-screen menu.. Use the on-screen menu to select the device you want to pair.. Select the Pairing Wizard option from the menu.. |