2022 nissan altima crankshaft position sensor location

The crankshaft position sensor on a 2010 Nissan Altima with a 2.5 liter engine is just below the starter on the driver side of the engine. You will need a 10-millimeter socket, extension and ratchet to remove it. The easiest way to get at it by far is from underneath the car. You'll have to jack the car up, if You need to replace the crankshaft position sensor You will not be able to start the car and drive it up Ramps. Unplug the electrical connector going to the sensor and then turn the hex head bolt counterclockwise to remove it. You may have to give the sensor a little wiggle while pulling out on it in order to free it up from its slot. When installing a new sensor make sure You do not over tighten the bolt otherwise You could crack the plastic and damaged the sensor.

Table of Contents Show

Does Nissan Altima have crankshaft sensors?
Where is the crankcase position sensor?

accountCircle

Ron Hutchins July 10, 2021

The Crank Sensor is on the Rear of the Engine

accountCircle

Elaine M July 16, 2020

The 2010 nissan altima 2.5 Crankshaft position sensor is located on the back side and drivers side of the engine.

The Questions and Answers on this page are the statements and opinions of their respective authors and not VehicleHistory.com. VehicleHistory.com does not research or authenticate any of the Answers provided.

I change the engine, after that, I have crank to much to star de engine, some time star fast and some time I have to wait 5 o 10 minute cranking the engine to start. I check the timing, is ok, the cps line to the ecu, ok I, change the ecu and the bcm the same thing, I dont fine any information of this car, I somebody can help me with the wiring diagram, y don, know this car, if you start the engine and disconnect the crank position sensor, the engine continue on, I dont know what else do?

15% off

your next purchase.
Some exclusions apply.

Enter coupon code: in shopping cart.

We look forward to serving you,
The Advance Team

Does Nissan Altima have crankshaft sensors?

Your Nissan Altima will be happy to know that the search for the right Crankshaft Position Sensor products you've been looking for is over! Advance Auto Parts has 32 different Crankshaft Position Sensor for your vehicle, ready for shipping or in-store pick up.

Where is the crankcase position sensor?

The location of the crankshaft position sensor can vary from one vehicle to another. Obviously it must be close to the crankshaft, so it is most often located on the front underside of the engine. It can usually be found mounted to the timing cover. Sometimes it may be mounted at the rear or the side of the engine.

nissan altima crankshaft position sensor location