The crankshaft position (CKP) sensor on your 4.6L or 5.4L Ford pick up (SUV or car) is a two wire type CKP sensor that you can easily and accurately test with a multimeter in Volts AC mode. Show You don't need a scan tool to test the Ford 4.6L, 5.4L crankshaft position sensor (although a scan tool is a must-have tool now-a-days). This tutorial will walk you thru' the whole thing step by step. You can find this tutorial in Spanish here: Cómo Probar El Sensor De La Posición Del Cigüeñal (Ford 4.6L, 5.4L) (at: autotecnico-online.com). Important Tips And SuggestionsTIP 1: The crankshaft position sensor is located on the timing chain cover. More specifically, it's located to the right (passenger side) of the crank pulley and behind the A/C compressor. TIP 2: It's very important that the battery on your Ford car (pick up or SUV) must be fully charged for this test. The battery must have enough reserve power to crank the engine easily for several seconds. TIP 3: You'll need to jack up the vehicle to gain access to the CKP sensor. Use a jack stand to hold the car up in the air. Do not trust the jack! Wear safety glasses to protect your eyes from falling debris. Think safety all of the time! TIP 4: When the CKP sensor goes bad, you'll get a no-spark no-start condition. So, if you're getting spark from the ignition coil pack or the Coil-On-Plug ignition coils, then you can conclude that the crankshaft position sensor is good and this test will not help you. Since so many things can cause a ‘cranks but does not start’ condition, the following tutorial may give you some more diagnostic/troubleshooting insights:
Where To Buy The Crankshaft Position Sensor And SaveYou can find the crankshaft position sensor for your Ford in any auto parts store. If you're wanting the buy the original Motorcraft crankshaft position sensor, you can buy it online for a whole lot cheaper than somewhere local. The following links will help you comparison shop for the Motorcraft and after market CKP sensor: Will the above crankshaft position sensor sensor fit your particular Ford pickup (car or SUV)? Don't worry, once you get to the site they'll make sure it fits (by asking you the specifics of your particular Ford/Mercury vehicle). If it doesn't fit, they'll find you the right one. The crankshaft position (CKP) sensor is one of the most critical components to get the engine in your Ford car (pick up, SUV, van) started. Since it provides the signal the PCM needs to start injecting fuel and start creating spark. Here are some specifics of the crankshaft position sensor: The 4.6L, 5.4L CKP sensor is a two wire variable reluctance sensor. What this means is that:
Coil Pack Ignition System: If your specific Ford vehicle has an ignition control module (4.6L coil pack vehicles):
Coil-On-Plug (COP) Ignition System: If your specific Ford vehicle does not use an ignition control module and is the Coil-On-Plug ignition system type:
In the next section, I'll go into some of the symptoms of a bad CKP sensor. What are the symptoms of a failing crank sensor?5 Signs of a Failing Crank Sensor. Crank Sensor Problems Could Make it Hard to Start Car. One sign that your crankshaft sensor might be failing is if you find it hard to start your vehicle. ... . Engine Vibration Issues. ... . Fuel Economy Slippage. ... . Uneven Acceleration. ... . Check Engine Light On.. |